Опубликовано: 17.06.2022
1- AC alternating current transformer type welding equipment: Modifies the electric current, lowering the voltage and intensity of the low voltage and high amperage power supy network, safe for welding, which type of transformer used in arc welding answer. This type of maine is eaper, but it is heavier, offers lower amperage and higher energy consumption.
Welder investors also win at this point. They are more efficient since they manage to maintain a certain amount of energy for longer than transformers. Likewise, the size of the unit is approximately three times lighter and more compact, whi allows use in aces that are difficult to access.
A transformer-type welding power supy converts moderate voltage and moderate current electricity from the utility power grid (typically 230 or 115 VAC) into a high current, low voltage supy, typically between 17 and 45 (open circuit) volts and 55 to 590 amps.
This process produces a DC voltage of 325 or 650 volts.
Advantages of conventional welders We can talk about some small advantages of this equipment, whi in the end are not so useful compared to the new tenology: The quality of this equipment is excellent, surpassed only by very good Inverter welding equipment. They are easier to repair and less expensive.
The basic equipment necessary for the electric arc welding process consists of the following elements: – current source; - cables; – electrode holder gun or clamp; – earth clamp; – shielding gas (type depending on the process) and hoses; – safety elements (mask, gloves and uck).
Inverter welding equipment is a modern and digitized version of classic welding maines. The operation of both is based on the same concept, the transformation of alternating current into direct current to create a voltaic arc.
Traditional Welders, also called Traditional or Transformers, are made up of a transformer that reduces the voltage and a unit of diodes, whi allow the alternating current of the network to be converted into direct current.
Electric welding equipment is made up of: Electrode: metal rod, generally mild steel, covered with a material that later forms the slag, protecting the weld from corrosion.
This “pressure”, whi induces an electric current, is called potential difference, tension or voltage. All welding maines have regulators, whi allow the amperage or intensity of electric current necessary to weld to be varied.
When the 220V voltage of the welder is multiied by 1.7380v, multiied by 1.4, this is the loss factor and the power of the welder, and the minimum power of the generator is obtained.